User manual

42
8. DISPLAY INDICATION AND SYMBOLS
AUTO Automatic measuring range selection
MANUAL Manual measuring range selection
TRMS True root mean square
HOLD Data hold function
OL Overload (measuring range exceed)
Battery replacement symbol (low battery level)
Diode test
Acoustic continuity tester
AC Alternating current for voltage and current
DC Direct current for voltage and current
mV millivolt (= 0.001 V)
V Volt (unit of electric voltage)
A Ampere (unit of electric current)
mA milliampere (= 0.001 A)
µA Microampere (=0.000001 A)
Hz Hertz (unit of frequency)
kHz Kilo Hertz
MHz Mega Hertz
VA Voltampere (unit of electric apparent power)
ºC Degree Celsius (unit of temperature)
ºF Degree Fahrenheit (unit of temperature)
Ω Ohm (unit of electric impedance)
kΩ Kilo Ohm (= 1000 Ω)
MΩ Mega Ohm (= 1000000 Ω)
nF Nanofarad (unit of electric capacity, = 0.000000001 F)
µF Microfarad (= 0.000001 F)
mF Millifarad (= 0.001 F)
Symbol for capacitance measurement
9. POWER THE PRODUCT
The product is powered by either six 1.5 V batteries type C or 230 V/AC, 50 Hz. Based on your needs,
select one of the methods below to power the product.
Battery
Disconnect the product from the power source before opening the power
compartment.
Disconnect the measuring leads from the product before opening the power
compartment.
Never operate the meter when it is open. Danger to life!
A new, fully charged battery must be inserted at initial commissioning or if the battery change symbol
appears on the display.