Instructions

58
16. Deleting data
Generate and save the PDF report before deleting measured data, if needed.
 Deletingdatadoesnotaffectthecongurationsettings.
• Press and hold down the “DOWN” (6) and “ENTER” (8) buttons and connect the data logger to your computer.
“USB”isshownintheLCdisplay.Alldataisdeleted.
• Release the buttons. The data logger is recognised as a removable disc.
• The data logger folder on your computer is empty, which means that all data have been deleted successfully.
Disconnect data logger from your computer.
17. Updating rmware
 Downloadthelatestdataloggerrmwarefromtheproductpageonwww.conrad.com.
Press the “DOWN”button(6)repeatedlyuntilthefour-digitloggeridentierand“ID”appearonthedisplay.
Press and hold down the “ENTER”button(8)untilthefour-digitloggerIDisreplacedby“ ”.
Keepthe“ENTER”
button (8) pressed
→
• Connect the data logger to your computer.
• Draganddropthermwaretothedataloggerdriveonyourcomputer.
• Dataloggerstartsupgrading.Duringthistime,thedataloggerwillbrieynotbedisplayedasaremovabledisc.Do
not disconnect data logger from your computer!
• As soon as the data logger appears again as a removable disc, the update is completed. Green LED control light
ashestwice.
• Disconnect the device from your computer.
 ThermwareversionofthedataloggercanbecheckedintheleftbottomcornerofthePDFreport.