Instructions

57
15. Creating a report
a) PDF report
The PDF report contains general information about the device, data logger settings, alarm status, minimum/maximum
values, and a graph showing the measured values over the logged time.
• Connect the data logger to your computer.
• APDFreportisproducedautomatically.TheredLED(2)goesonand“USBPDF”appearsontheLCdisplay(5).
Do not disconnect the data logger from your computer during this period.
• OncethePDFlehasbeengeneratedsuccessfully,“PDF”disappearsfromtheLCdisplay(5).“USB”remainson
the LC display. After creating the report, the data logger will be recognised by the computer as a removable disc.
• Open the data logger drive on your computer.
• SelectandopenthePDFle.
• The PDF report contains general device information, data logger settings, alarm statuses and a graph showing the
measured values during the recorded time.
• SavethePDFleonyourcomputerandclosethele.
• Disconnect data logger from your computer.
 GeneratingthePDFlecantakeabout30secondsdependingonthenumberofmeasurementssaved.
The PDF report contains only the highest and lowest measured values recorded during logging (not during
the pause function).
b) CSV report
The CSV report shows all measured values during recording in tabular form. These data can be used to create various
evaluations and protocols by means of spreadsheet programs. The CSV report and the PDF report are generated
simultaneously. The procedure is identical to the generation of the PDF report.