Instructions

55
e) Display of the remaining time until recording start/stop
• To call up the function menu, press the “DOWN” button (6).
• Press the “DOWN” button(6)repeatedlyuntil“TIMESTART”or“TIMESTOP”andtheremainingtime(inhours/
minutes or days) appear on the LC display.
Timedurationsbelow24hoursaredisplayedinHH:MMformat.
Iftheremainingtimeexceeds24hours,itwillbedisplayedindays:“ ”.
• Once the recording starts/stops, the latest measurement is shown in the display.
• To go back to the function menu, press the “DOWN” button (6).
f) Enabling/disabling the alarm limit pause function
Toenable/disablethealarmlimitpausefunctionduringrecording,thealarmlimitmustbeenabledduringthecongu-
ration(seechapter“12c)Measurement-AlarmSettings”).
Keepthe“ENTER” button (8)
pressed→pauseon
Keepthe“ENTER” button (8)
pressed→pauseoff
Toenable/disablethelimitpausefunction,pressandholddownthe“ENTER” button (8) for a few seconds.
Once the alarm pause function is enabled/disbaled, the latest measurement will be shown in the display.
Recorded values during activated pause function are shown in the report graph as usual. However, the
graph clearly shows when and for how long the pause function was enabled.
 Whenthelimitpausefunctionisenabledduringrecording,thereisnoalarmindicator“ ”or“ ”. The
LED alarm status and the minimum and maximum values are not updated.