Instructions

49
13. Data logger operation modes and displays
a) Operation modes and settings
Tomakethecongurationeasier,13commonoperationmodesarelistedhere.Tomakethefollowingconguration
settings,refertochapter“12b)Measurement-basicsettings”.
Mode 1
Feature Logging starts immediately.
Logging stops when memory is full.
Setting • As“Loggingstartcondition”,select:“Immediatelyaftermemoryisfull”
Mode 2
Feature Logging starts immediately.
Theloggingwillstopifyoupressandholddownthe“ENTER” button (8) for a few
seconds.
Setting • As“Loggingstartcondition”,select:“Immediatelyaftermemoryisfull”
• As“Loggingendcondition”,select:“Stopbutton”
Mode 3
Feature Logging starts immediately.
Logging stops after PDF report is generated.
Setting • As“Loggingstartcondition”,select:“Immediatelyaftermemoryisfull”
• As“Loggingendcondition”,select:“AfterPDFcreation”
Mode 4
Feature Theloggingwillstartifyoupressandholddownthe“ENTER” button (8) for a few
seconds.
Logging stops when memory is full.
Setting • As“Loggingstartcondition”,select:“Startuponkeypress”
Mode 5
Feature Theloggingwillstartandstopifyoupressandholddownthe“ENTER” button (8) for a
few seconds.
Setting • As“Loggingstartcondition”,select:“Startuponkeypress”
• As“Loggingendcondition”,select:“Stopbutton”