Instructions

44
b) Creating the conguration le
• Connect the data logger to your computer.
• Launch the Voltsoft software and follow the operating instructions in the software manual (section 6 and choose
your supported device).
• Aftercreatingthecongurationle,saveitlocallyonyourcomputerandcopytheletothedatalogger.
• Disconnect data logger from your computer.
12. Online conguration with the website
Afterinsertingthebattery,congurethedataloggereitherwithsoftwareoronlinethroughthewebsite.Onlinecongu-
rationdoesnotrequiresoftwareinstallation.
Whenconguring,selectloggingparameterssuchassamplerate,starttime,recordingduration,pausefunction,LED
ashinterval,enable/disableLCdisplay,andPDFreportsettings.
Therearethreewaystoopenthecongurationwebsite:
• Open www.conrad.com in a browser and navigate to the product page using the article number of the data logger
(1931527).Clickonthelinkforthecongurationwebsitetoopenthewebsite.
• InanInternetbrowser,openthefollowingInternetaddress:http://datalogger.voltcraft.com/CongBuilder/index.jsp
• Connect the data logger to your computer and wait until it has been connected as a removable disc. Open the data
logger drive on your computer. Click on the “CongurationWebsite.html” link to open it.
a) Overview of the conguration interface
Thecongurationinterfaceconsistsofthreeareas.
General Settings:
Atthetopright,youcansetlanguagesbyclickingoncountryags.Clickonyourcountryagtoswitchtothenational
language.
Below,youcanselectthemodeltype.Selecttype“DL-230L”fromthelistandclickonit.
Measurement
In this area you can select all basic settings and logging parameters for the data logger.
PDF area options
In this area, you can enter all parameters for PDF report generation.
Storage options
Youcanusethethreelowerselectionelds“CreateConguration”,“LoadSetting”and“Default”tosave,loadorreset
thecongurationstodefaults.