Instructions

10
8. Setup
When connecting batteries, always observe the polarity and the charging instructions from the relevant battery manu-
facturer.
Always supply the charger with power before connecting the rechargeable battery. This also applies to the balancer
connection.
After use, disconnect the charger from the power source and unplug the rechargeable battery.
Setting up power supply
Power is supplied via the side XT60 connector (8) on the left. The rechargeable batteries to be charged are connected
via the XT60 connection on the right side (5).
The polarity is specied by the connector geometry. The XT60 socket must show the polarity.
After a brief system test, the parameters will be shown on the display.
9. Operation
Supply the charger with power. The charger will start with a system test and fan test conrmed by a beep.
Some settings must be made before operating the charger.
To operate the charger, use the knob with press function (2). To select menu items, turn the knob. To conrm the selec-
tion, press the knob. This procedure applies to all settings (system and programme settings).
The setup menus are largely self-explanatory and can be easily set up using predetermined parameters.
Main display
The main display shows basic parameters of the currently connected rechargeable battery/rechargeable battery pack.
The main display colour also provides information about the current status:
Grey background colour = standby
Blue background colour = charging mode
Green background colour = rechargeable battery is charged
Orange background colour = discharge mode
Red background color = battery is discharged