Operation Manual

CHARGE STATUS DISPLAY FOR THE INTEGRATED

RECHARGEABLE BATTERY

Press the button (7). The voltmeter (3) indicates the charging state of the rechargeable battery. The dis-

play hand should be in the green range. If the display hand is in the yellow range, recharge the battery.

For use of the starting aid function, the battery should be charged to at least 75%.

8. WORKING LAMP

The switch (10) is used to switch the working lamp (13) on and off. Switch the working lamp off when you

are not using it to save power.

9. USB OUTPUT

Small consumers with USB plugs can be operated at the USB port (11). The USB port delivers 5 Volt with

up to max. 500 mA and is not a data port. The switch (14) is used to switch the voltage at the port on and

off.

10. 12V-OUTPUT SOCKETS

The quick-start system has two 12V output sockets (12) used to connect suitable devices, e.g. a car

charging adapter for mobile phone or similar. Use the switch (14) to switch the voltage at the sockets on

or off.

Please observe that the device connected to the socket must not have any power intake of more than

10A. If the output current is higher, the internal fuse will trigger. Remove the device connected to the

socket. The internal fuse will reset after a short time.

Since the output socket is directly connected to the internal battery via the on/off switch, always ensure

that the connected device is unplugged in time to prevent deep discharge of the internal battery.

11. AIR COMPRESSOR

Open the cover of the storage compartment (20) in the rear. It contains the air hose for the air compres-

sor. The included adapters (24) can be used to charge not only vehicle tyres but also, e.g. soccer balls

or similar.

Use the on/off switch (14) to switch the air compressor on or off. A manometer (1) is used for general air

pressure measurement, e.g of a tyre.