Instructions

5.17.20 [LowLine Edit►]
Lower line editing is used to edit the control line above the trace,
depending on the trace.
5.18
【
Meas Setup
】
Measurement setting menu for the corresponding measurement
parameter settings when adjacent channel power, channel power,
occupied bandwidth measurement mode is turned on.
5.18.1 [Channel BW]
Set the bandwidth of the channel power measurement, and set the
total display power percentage of bandwidth.
5.18.2 [Channel Interval]
Set the center frequency difference of the primary channel to the
adjacent channel.
5.18.3 [Channel Nums
Set the number of upper and lower adjacent channels measured
by adjacent channel power.
5.18.4 [Power Percent]
Set the power ratio of occupied bandwidth.
55