Instructions

frequency line is scanned. The peripheral stops scanning; the full
frequency is scanned when it is closed.
5.17.14 [Limit Meas►]
Enter the soft menu of the area measurement mode.
5.17.15 [Limit Meas On Off]
Turn On or Off area measurement mode.
5.17.16 [Line Up On Off]
When the upper limit line is turned on or off, the upper limit line is
opened by default when the area measurement is on.
5.17.17 [Line Low On Off]
When the lower limit line is turned on or off, the lower limit line is
opened by default when the area measurement is on.
5.17.18 [Shift X/Y Frequency Amplitude]
Frequency: For the actual measurement, the edited area as a
whole superimposed on a frequency, so that it can implement left
or right shift, easy to measure. Does not affect the frequency and
marker of the spectrum analyzer settings.
Amplitude: The region has been edited on the whole
superimposed on a degree, so that it can move up or down, easy
to measure. Does not affect the amplitude setting of the spectrum
analyzer.
5.17.19 [UpLine Edit►]
Upper line editing is used to edit the control line above the trace,
depending on the trace.
54