Instructions

Defines the content displayed or hidden in the comments that

appear in the display grid area.

5.9

【

Sweep

】

Sets parameters about the Sweep time and mode including

[Sweep Time Auto Manual]. [Sweep Single], [Sweep Cont]].

5.9.1 [Sweep Time Auto Manual]

Sets the time interval for the analyzer to complete a sweep.

 In non-zero span, the analyzer uses the shortest sweep time on

the basis of the current RBW and VBW settings if Auto is

selected.

 You can modify this parameter using the numeric keys, knob, or

direction keys.

5.9.2 [Sweep Single]

Press [Single Sweep] to set the sweep mode to Single. Press

[Single Scan] to restart the scan when the next trigger signal

arrives. Allows you to set continuous scan mode.

5.9.3 [Sweep Cont]

Press [Continuous Scan] to activate the sweep scan mode.

5.9.4 [Sweep Points]

Sets the desired points for every sweep. That is the number of

points of the current trace.

Key Points:

 Changing the points may influence the sweep time which is

limited by the sample rate of the ADC (Analog to Digital

Converter). That is, the more points used, the longer the sweep