Instructions

Sample

Sampling detector is conducive to

measurement noise signal. Compared with the

standard detection method, it can measure

noise better.

5.7.1 [Auto]

Set the detector to auto detection mode (default mode). In this

mode, when the span is greater than 1MHz, the detection method

is set as Normal. When the span is less than or equal to 1MHz, the

detection method is set as Positive Peak.

5.7.2 [Normal]

When noise is detected, the positive and negative peaks are

alternately displayed, otherwise only positive peaks are displayed.

5.7.3 [Pos Peak]

Searches the maximum from the sampling data segment and

displays it at the corresponding pixel. Positive peak detector will be

selected when [Max Hold] pressed.

5.7.4 [Neg Peak]

Searches the minimum from the sampling data segment and

displays it at the corresponding pixel.

5.7.5 [Sample]

Set the detector to the sampling detector mode. This mode is

usually used for video averaging and noise frequency Maker.

5.8

【

Display

】

Controls the screen display of the analyzer, such as setting the on

or off for window zoom, display line, amplitude scale, grid, label,