Instructions

5.5.5 [EMI BW►]
Pop out the menu for EMI measurement bandwidth.
1) [EMI bandwidth On Off]
Turn on or off EMI measurement resolution bandwidth.
2) [1MHz]
Set EMI measurement resolution to 1MHz.
3) [120kHz]
Set EMI measurement resolution to 120kHz.
4) [9kHz]
Set EMI measurement resolution to 9kHz.
5) [200Hz]
Set EMI measurement resolution to 200Hz.
5.6
【
Trace
】
As the sweep signal is displayed as a trace on the screen, you
can set parameters about the trace using this key. The analyzer
allows for up to five traces to be displayed at one time, and press
this key to check the menu for trace. It includes [Trace 1 2 3 4 5],
[Clear Write], [Max Hold], [Min Hold], [Blank], [Check], [ 1 ↔ 2],
[ 2 - DL → 2], [ 2 ↔ 3], [ 1 → 3] and [ 2 → 3].
5.6.1 [Trace 1 2 3 4 5 ]
Select trace, the analyzer offers 1,2,3,4,5 trace. The selected trace
and corresponding status menu will be underlined.
5.6.2 [Clear Write]
Refresh current curve and display the analyzer trace.
5.6.3 [Max Hold]
Maintains the maximum for each point of the trace. It continuously
receive scan data and select positive peak value detect mode.
34