Instructions

The output of the tracking generator can be connected to a
receiver through an N type male connector, users can purchase
this option if required.
!
CAUTION
Input voltage at RF input port must not be higher than 50 V
DC to avoid damage to the attenuator and input mixer
tracking generator.
3. RF Input 50Ω
The RF input may be connected to a device via a N type connector
!
CAUTION
When input attenuator is higher than 10 dB, the RF port
input signal must be less than +30 dBm.
4.5 Rear Panel
8 7 6 5 4 3
1
2
Figure 4-6 Rear Panel
Table 4-4 Rear Panel Description
NO.
Name
Description
16