User manual
9
7. Overview of parts
1 Graphical display
2 Adjusting wheel with sensor function
3 Input power supply XT60 (9 – 32 V/DC)
4 PC Link interface
5 Balancer terminal block
6 Ventilation openings
7 XT60 charge/discharge output connector
8. Setup
When connecting batteries, always observe the polarity and the charging instructions of the battery manufacturer
concerned.
Always supply the charger with power before connecting the rechargeable battery. This also applies to the balancer
connection.
After use, disconnect the charger from the power source and unplug the rechargeable battery.
Setting up power supply
Power is supplied via the side XT60 connector (3) on the left. The rechargeable battery is connected via the side XT60
connector (7) on the right.
The polarity is specied by the connector geometry. When using the included XT60 connection cable,
please pay attention to the correct polarity when connecting it. The red crocodile clip corresponds to the
positive pole and the black crocodile clip corresponds to the negative pole. If you use a self-congured
connection cable, the polarity shown must be indicated on the XT60 socket.
After a brief system test, the parameters will be shown on the display.