Instructions

4.Advanced User Guidebook
26
4. Advanced User Guidebook
Up till now, you have already been familiar with the basic operations of the function areas,
buttons and knobs in the front panel of the oscilloscope. Based the introduction of the
previous Chapter, the user should have an initial knowledge of the determination of the
change of the oscilloscope setting through observing the status bar. If you have not been
familiar with the above-mentioned operations and methods yet, we advise you to read the
section of Chapter 3 "Junior User Guidebook".
This chapter will deal with the following topics mainly:
 How to Set the Vertical System
 How to Set the Horizontal System
 How to Set the Trigger/Decoding System
 How to Implement the Sampling Setup
 How to Set the Display System
 How to Save and Recall Waveform
 How to Record/Playback Waveforms
 How to Clone and Recall a waveform
 How to Implement the Auxiliary System Function Setting
 How to Update your Instrument Firmware
 How to Measure Automatically
 How to Measure with Cursors
 How to Use Autoscale
 How to Use Built-in Help
 How to Use Executive Buttons
 How to Print the Screen Image
It is recommended that you read this chapter carefully to get acquainted the various
measurement functions and other operation methods of the oscilloscope.