Instructions

10.Technical Specifications
125
10. Technical Specifications
Unless otherwise specified, the technical specifications applied are for DSO
dual-channel series only, and Probes attenuation set as 10X. Only if the oscilloscope
fulfills the following two conditions at first, these specification standards can be
reached.
 This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
 If change of the operating temperature is up to or exceeds 5℃, do a
"Self-calibration" procedure (see "How to Implement Self-calibration" on P14).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Oscilloscope
Performance Characteristics
Instruction
Bandwidth
8 bits mode
200 MHz
12 bits mode
150 MHz
14 bits mode
20 MHz
Vertical Resolution (A/D)
14 bits
Channel
2 + 1 (External)
Waveform Refresh Rate
75,000 wfms/s
Multi-level Gray Scale Display &
Color Temperature Display
(Use gray scale to indicate frequency of
occurrence, where frequently occurring
waveform are bright.)
Support
Magnifier Function
(The magnifier window can display the
magnified wave of the wave selection.)
Support
Acquisition
Mode
Normal, Peak detect, Averaging
Sample rate
(real time)
Dual
CH
8 bits mode
1 GS/s
12 bits mode
500 MS/s
14 bits mode
100 MS/s
Single
CH
8 bits mode
1 GS/s
12 bits mode
500 MS/s
14 bits mode
100 MS/s
Input
Input coupling
DC, AC , Ground
Input impedance
1 MΩ±2%, in parallel with
15 pF±5 pF
；
50Ω ± 2%
Input coupling 0.001X - 1000X, step by 1 – 2 - 5
Max input voltage
1MΩ
：
≤300 Vrms;
50Ω
：
≤5 Vrms (For certain models)