Instructions

5.Use the Arbitrary Function Generator (Optional)

Click to increase the

value of cursor position

Move the cursor

Click to decrease the

value of cursor position

To Set the Period

Select Period in the right menu (if Period is not displayed, select Frequency and select it

again to switch to Period). Set the parameter in the right menu.

To Set the Start Phase

Select StartPhase in the right menu. Set the parameter in the right menu.

To Set the Amplitude

Select Amplitude in the right menu (if Amplitude is not displayed, select High Level and

select it again to switch to Amplitude). Set the parameter in the right menu.

To Set the Offset

Select Offset in the right menu (if Offset is not displayed, select Low Level and select it

again to switch to Offset). Set the parameter in the right menu.

To Set the High Level

Select High Level in the right menu (if High Level is not displayed, select Amplitude

and select it again to switch to High Level). Set the parameter in the right menu.

To Set the Low Level

Select Low Level in the right menu (if Low Level is not displayed, select Offset and

select it again to switch to Low Level). Set the parameter in the right menu.

To Output Square Signals

The parameters of Square waveform are: Frequency/Period, Start Phase, Amplitude/High

Level, Offset/Low Level.

To set the Frequency/Period, Start Phase, Amplitude/High Level, Offset/Low Level, please

refer to To Output Sine Signals on page 95.

To Output Ramp Signals

The parameters of Ramp waveform are: Frequency/Period, Start Phase, Amplitude/High