User manual

c) Voltage measurement “V”

Proceed as follows to measure direct voltages “V ”(DC):

- Switch the DMM on and select the “V ” measurement

mode. “DC” and “V” will appear on the display.

- For lower voltages up to max. 600 mV, select the “mV ”

measurement function.

- Insert the red lead into the V socket (G) and the black lead into

the COM socket (H).

- Connect the two measuring probes to the object to be meas-

ured (battery, switch, etc.). Connect the red measuring probe

to the positive terminal and the black measuring probe to the

negative terminal.

- The polarity of the measurement is indicated on the display.

- After taking a measurement, remove the leads from the meas-

ured object and switch the DMM off.

If “-” appears in front of a direct voltage measurement, this indicates that the measured voltage is negative

(or that the test leads have been connected in reverse).

 The“VDC/AC”voltagerangehasaninputresistanceof>10MΩ.ThemVrangehasaninputresistanceof

≤1000MΩ.Ifopenmeasuringinputsareused,anundenedmeasurementvaluemaybedisplayedinthe

mV range due to the high input resistance. This, however, has no effect on the measurement result.