User manual

48
8. Display elements and symbols
The following symbols and letters appear on the device/display. Other symbols may appear on the display (display
test), but these have no function.
1 True RMS measurement
2 Delta symbol for relative measurement
(= reference measurement)
3 Mega symbol (exp.6)
4 Kilo symbol (exp.3)
5 Ohm (unit of electrical resistance)
6 Hertz (unit of frequency)
7 Nano symbol (exp.-9)
8 Milli symbol (exp. -3)
9 Volt (unit of electrical voltage)
10 Micro symbol (exp. -6)
11 Ampere (unit of electrical current)
12 Farad (unit of electrical capacity)
13 Degrees Celsius (unit of temperature)
14 Degrees Fahrenheit (American unit of temperature)
15 Display of the pulse duration of the positive half-wave
as a percentage (pulse-pause ratio)
16 Automatic shut-off is enabled
17 Measured value display
18 Diode test symbol
19 Acoustic continuity tester symbol
20 Low impedance symbol
21 Correct socket assignment indicator
22 Automatic measurement range selection is enabled
23 Battery replacement indicator
24 Hold function is enabled
25 Direct current symbol ( )
26 Polarityindicatorforcurrentowdirection(negative
terminal)
27 Alternating current symbol ( )
28 Warning symbol for dangerous voltage