Manualshelf

User manual

ManualsBrandsVOLTCRAFT ManualsTest & MeasurementVC-271 Handheld multimeter Digital Calibrated to: Manufacturer's standards (no certificate) CAT III 600 V Dis
51525354555657585960
52
i) Measuring frequency
The multimeter can be used to measure the frequency of a signal
voltage (supports frequencies from 10 Hz to 10 MHz). The maximum
input is 20 Vrms. This mode is not suitable for taking measurements
onmainsvoltages.Observetheinputspecicationsinthetechnical
data.
Proceed as follows to take a frequency measurement:
- Switch on the DMM and select “Hz” mode. “Hz” will appear on the
display.
- Plug the red lead into the Hz terminal (G) and the black lead into
the COM terminal (H).
- Connect the two measuring probes to the object that you want to
measure (e.g. signal generator or circuit).
- The frequency and corresponding unit will be displayed.
- After taking a measurement, remove the leads from the measured
object and switch off the DMM.