Instructions

c) Inserting the battery, selecting the operating mode, setting the

charging current

• Insertasuitablerechargeablebatteryintoanybatteryslot(2),observingthecorrectpolarity

(notepositive/+andnegative/-,seethelabelinthebatterycompartmentandonthebattery).

 Duetothedesign/sizeofbatteriesoftypeC,onlytwoofthefourbatteryslotscanbe

used.

• Thevoltageofthebatteryappearson the corresponding LC display and the “CHARGE”

operatingmodeashesforfourseconds.Duringthistime,youcanpressthe“MODE”key(6)

repeatedly to select the operating mode.

• “300mA”isthendisplayedasthechargingcurrentandtheoperatingmode“CHARGE”or

“CHARGETEST”ashes.Duringthistime,youcanpressthe“CURRENT”key(4)repeatedly

to select the charging current.

• When no button has been pressed for a few seconds, the charging process starts.

If, after inserting the battery, no voltage is displayed, either the battery contacts have

oxidised or are highly resistive, or the battery has discharged deeply or is faulty.

Whether or not a different operating mode can be selected or the charging current can

bechanged,pleaserefertoChapter8.d)and8.e).

d) Subsequently changing the operating mode or charging current

for a single battery slot

• Pressthecontrolkey (3) fortherespectivebattery slot whose operatingmodeorcharg-

ing/dischargingcurrentyouwanttochange.ThecorrespondingindicatorontheLCdisplay

ashes(pressthecontrolkeyforthebatteryslot2x,ifnecessary).

• Selecttheoperatingmodebybrieypressingthe“MODE”key(6).

• Changethechargingcurrentbybrieypressingthe“CURRENT”key(4).

• Wait a few seconds, the settings are applied.