User manual

55
b) Direct voltage (V/DC)
 TheV/DCvoltagerangehasaninputresistanceof≥10MΩ,meaningthereisalmostnoimpactoncircuit
performance.
• Select < > mode. [ DC V ] will appear on the display.
• The main display indicates the measured voltage.
- A minus symbol indicates that the measured DC voltage is negative (or that the measuring leads are
connected in the wrong polarity).
c) Alternating voltage (V/AC)
 TheV/ACvoltagerangehasaninputresistanceof≥10MΩ,meaningthereisalmostnoimpactoncircuit
performance.
• Select < > mode. [ AC V ] will appear on the display.
• The main display indicates the measured voltage.
• The small display indicates the measured frequency.
d) Alternating voltage (V/AC) – Low Pass Filter
Thelowpasslterinterceptsvoltagesexceeding1kHz.
• Select < LPF > mode. [ AC V ] will appear on the display.
• The main display indicates the measured voltage.
• The small display indicates the measured frequency.
e) AC + DC voltage
• Select < AC+DC > mode under < >. [ V ] will appear on the display.
• The main display indicates the measured voltage in form of .
• The small display alternates between displaying the measured DC voltage and AC voltage.
f) LoZ alternating voltage
< > mode allows you to measure AC voltages with a low impedance
(approx.300kΩ).Inthismode,themultimeterlowerstheinternalresistanceto
prevent ‘phantom’ voltage readings. As a result, the circuit is more heavily loaded
than in the standard measuring mode.
 The LoZV/AC voltagerange has aninput resistance of<300 kΩ,
which may slightly affect circuit performance.
• Select < > mode. [ AC V ] will appear on the display.
• The main display indicates the measured voltage.
• The small display indicates the measured frequency.