Manualshelf

User manual

ManualsBrandsVOLTCRAFT ManualsTest & MeasurementVC-595OLED Clamp meter Digital Calibrated to: Manufacturer's standards (no certificate) OLED display CAT III 6
51525354555657585960
60
f) Continuity test
Make sure that the circuit components, circuits and components to be
measured or any other measuring objects are voltage-free and discharged.
- Turn on the DMM and select the measuring range . Press
the SELECT key to switch to the correct measuring function.
The display shows the symbol for continuity test. Pressing the
key again will switch to the next measuring function, etc.
- Insert the red test lead into the V test socket (10) and the black
test lead into the COM test socket (9).
- Ameasurementof<10ohmisidentiedascontinuity;inthis
case, a beep sounds. The measuring range extends to max.
600 ohm.
- The measuring range is exceeded or the circuit interrupted if
the display shows „OL“ (for overload).
- Remove the test leads from the measuring object and turn off
the DMM after measurement.