User manual





 



- Turn on the DMM and select the measuring range

Press the SELECT key twice to switch to the correct

measuring function. The display shows the symbol for

diode test. Pressing the key again will switch to the

next measuring function, etc.

- Insert the red test lead into the V test socket (10) and

the black test lead into the COM test socket (9).

- Check the test leads for continuity by connecting the

test prods to one another. The device should then

- Connect the test prods to the measuring object (diode).

- The display shows forward voltage „UF“ in volt (V).

If the display shows OL, the diode is measured in

reverse direction (UR) or the diode is defective (inter-

rupted). For checking purposes, conduct a measure-

ment on the opposing poles. A beep sounds in case of forward voltages <0.1 V.

- Remove the test leads from the measuring object and turn off the DMM after measurement.