User manual

50
d) DC Voltage Measuring “V ”
Proceed as follows to measure direct voltages “DC” (V ):
- Turn the DMM on and select measuring function “V ”.
The display indicates “DC”.
- Plug the red measuring line into the V measuring jack (9)
and the black measuring line into the COM measuring jack
(8).
- Connect the two measuring prods to the object to be
measured (battery, circuit, etc.). The red measuring prod
indicates the positive pole, the black measuring prod the
negative pole.
- The current measured value is displayed together with the
respective polarity.
If a minus “-” appears in front of the measured value
for direct voltage, the measured voltage is negative
(or the measuring lines are swapped).
The voltage range has an input resistance of
≥10 MOhm.
- Remove the measuring lines from the object to be measured after completion of the meas-
urement and switch off the DMM.