User manual

e) HOLD function

• With the HOLD function, the current measurement value is shown on the display and the

measurement process is put on hold.

• Enable the function by pressing the HOLD/

button. Press the button again to disable to

the function.

• <

> appears on the display when the function is enabled.

• You can continue measuring after you have disabled the function.

f) Recording minimum and maximum values

• With the minimum/maximum value function, minimum and maximum values can be

registered and displayed on the LCD display.

• Enable the function by pressing the MAX/MIN button (3). Disable the function by pressing

the MAX/MIN button for approximately 2 seconds. The values on the display disappear.

• Minimum value: To display minimum values, keep pressing the MAX/MIN button until

< MIN > appears on the LCD display.

• Maximum value: To display maximum values, keep pressing the MAX/MIN button until

< MAX > appears on the LCD display.

• Difference: If you wish to view the difference between the maximum and the minimum

values, keep pressing the MAX/MIN button until < MAXMIN > appears on the LCD display.

g) REL function

• The REL function allows you to take a benchmark measurement to avoid potential line

losses. The current display value is set to zero and saved as a new benchmark value.

• Press the REL button (6) to enable the function. < REL > appears on the display. Press

the REL button again to turn the function off. < REL > disappears from the display. The

benchmark value is reset when the function is turned off.

• The LCD display shows the measured deviations from the benchmark value.