Manual

Todeletethefaultcodepermanently,conrmagainwiththeOKbutton(2).
Followtheinstructionsonthedisplay(1).
Information
Erase fault codes had
success.
Please wait 10 seconds, Turn
ignition off and Switch on again.
Read fault codes to verify.
PresstheESCbutton(3)tocanceltheprocess.
11 OBD II diagnostics
11.1 Reading out fault codes
There are two types of fault codes:

“Hardcodes”or“Permanentcodes”arefaultsthatactivatethecheckenginelightonthe
dashboard when an emission-related fault is detected.

“Pending codes” arefaultsdetectedduring the current or last completed drivingcycle.
These codes will be cleared during the next drive should the faults not reoccur. These faults
do not activate the check engine light on the dashboard.
Select[ReadCodes]withbuttons (6)and (7),andthenpresstheOKbutton(2).
Diagnostic Menu
Read Codes
Erase Codes
I/M Readiness
Data Stream
Evap System Test
Vehicle Information
1/6
47