User manual


Do not switch the device on immediately after taking it from a cold to a warm environment. The conden-
sation that forms might destroy your device. Allow the device to reach room temperature before switching
it on.
When performing measurements at power rails and unisolated conductors, be particularly careful - there
is a danger of electrical shock. Wear the corresponding protective equipment according to the respective
safety provisions (e.g. gloves, etc.) to avoid injury from electric shock and light arc, etc.
Do not leave packaging material unattended. It may become a dangerous toy for children.
Where possible, do not work alone to enable help.
Also observe the safety information in each chapter of these instructions.

AC~ Alternate current
A Ampere (unit of electric current)
mV Milli-volt (unit of electric voltage)
mV/A Proportional ratio (mV per measured A)
Operating switch
Battery display “Battery full”; ashes slowly
Battery display “Battery empty”; ashes fast
Lock icon “Locked”
Lock icon “Unlocked”
Arrow for position mark