Security Datasheet

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 2127442
Material Safety Data Sheet
6. Accidental Release Measures
Personal Precautions, protective equipment, and emergency procedures
In case of rupture: Attention! Corrosive material. Avoid contact with skin, eyes and clothing. Ensure adequate ventilation. Use
personal protective equipment as required. Evacuate personnel to safe areas. Keep people away from and upwind of spill/leak.
Refer to protective measures listed in Sections 7 and 8.
Environmental Precautions
Prevent product from contaminating soil and from entering sewers or waterways.
Methods and materials for Containment
Stop the leak if safe to do so. Contain the spilled liquid with dry sand or earth. Clean up spills immediately.
Methods and materials for cleaning up
Absorb spilled material with an inert absorbent (dry sand or earth). Scoop contaminated absorbent into an acceptable waste
container. Collect all contaminated absorbent and dispose of according to directions in Section 13. Scrub the area with
detergent and water; collect all contaminated wash water for proper disposal.
7. Handling and Storage
Handling
The battery may explode or cause burns, if disassembled, crushed or exposed to fire or high temperatures. Do not short or
install with incorrect polarity.
Storage
Store in a cool, dry, well-ventilated area away from incompatible substances. Store locked up. Keep out of the reach of
children.
Other Precautions
In case of rupture. Handle in accordance with good industrial hygiene and safety practice. Avoid contact with skin, eyes or
clothing. Use personal protection equipment.
8. Exposure Controls/Personal Protection
Engineering Controls
Use adequate ventilation to keep airborne concentrations low. If used under conditions that generate particulates, the ACGIH
TLV-TWA of 3mg/m3 respirable fraction (10mg/m3 total) should be observed.
Personal Protective Equipment
Eye and Face Protection: None required for consumer use. If there is a Hazard of contact: Tight sealing safety goggles. Face
protection shield.
Skin and Body Protection: None required for consumer use. If there is a Hazard of contact: Wear protective gloves and
protective clothing.
Respiratory Protection: No protective equipment is needed under normal use conditions. If exposure limits are exceeded or
irritation is experienced, ventilation and evacuation may be required.
Page 3 of 6