Datasheet

0.3
2N
To bend the lead wires, secure the lead wires at least 3mm away from the
base of the epoxy coat by a cutting pliers and etc. and then bend the lead
wire side, but not the epoxy coat side.
Eliminate any event and/or circumstance where more than 2N pressure is
applied to the lead wires in the direction shown by the arrow or where the
lead is spread wide more than
60.3mm from the original position.
Voltage - Current Characteristics
Notes
Current (mA)
Voltage (V)
10
0.1 0.2 0.3 0.5 1 2 3 5 7 10 20 30 50 70 100
20
30
50
1
2
3
5
7
203AT-2
203AT-2
103AT-2
502AT-2
202AT-2
102AT-2
at 258C
Current (mA)
Voltage (V)
10
0.1 0.2 0.3 0.5 1 2 3 5 7 10 20 30 50 70 100
1
2
3
5
100
20
30
50
0.1
0.2
0.3
0.5
102AT-11
103AT-11
103AT-4
502AT-11
202AT-11
at 258C
The soldering time (the duration of the time) should be less than 7 seconds
when a soldering iron with 50W power at 3408C is applied to the portion of
the lead wire at least 5mm away from the thermistor body. (at the bottom
of the epoxy resin)
AT-2,3
7