Instructions

20
8 3 digit LED display for output current
9 3 digit LED display for output voltage
10 Fan opening for cooling the device
11 Fuse holder for the mains fuse
12 Shockproof cold device connector
13 “SENSE”connectionforautomaticvoltagecorrectiononthehigh-currentoutput(16and17)
14 Remotecontrolinputforvoltagecontrol(“VOLTAGEREMOTE”)
15 Function switch for remote control
16 Screwterminaljackhigh-currentoutput“minuspole”upto60A
17 Screwterminaljackhigh-currentoutput“pluspole”upto60A
8. Operation
The switched-mode mains power supply unit is not a charger. To charge batteries, use suitable chargers
with a charging current cut-off.
a) Connecting the power cable
1. Connect the provided shockproof power cable to the power connector (12, female) of the mains power supply.
Make sure it is plugged properly.
2. Connect the power cable to a shockproof mains socket with protective grounding.
b) Setting the desired output voltage
1. Make sure that there are no consumers connected to the mains power supply.
2. Switch on the mains power supply at the power switch (1). The power indicator (2) should light up.
3. Now use the DC control (6) to set the desired output voltage. The setting can be checked on the display (9).
c) Setting the xed voltage of 13.8 V (only SPS 1525/1540 PFC)
1. Make sure that there are no consumers connected to the mains power supply.
2. Switch on the mains power supply at the power switch (1).
3. Now set the wiper switch (5)underneaththedevicetothe“FIXED13.8V”position.
4. Theoutputvoltagehasnowbeenxedtothisvaluesandcannotbechangedviathecontrolonthefrontofthe
device. The voltage is shown on the display (9).
5. Todeactivatethexedvoltage,slidethewiperswitchtotheoppositedirection.