User manual

24
8. COMMISSIONING
• Switch on the mains unit at the mains switch (6).
Switch position „I“ = on
Switch position „O“ = off
• Take the connected device into operation (e.g. a charger).
• Depending on the current output current, the LED display (1) on the front lights up (the more
LEDs are lit, the higher the output current; each LED represents a current of approx. 2 A).
If all LEDs go out in case of error, the mains unit will switch off for 10 seconds and then
on again.
• The fan is automatically activated depending on the inner temperature of the mains unit.
• If you no longer need the mains unit, switch it off and disconnect it from the mains voltage.
Pull the mains plug from the mains socket.
9. MAINTENANCE AND CLEANING
The product does not require any maintenance. You should never take it apart.
The product should only be repaired by a specialist or specialist workshop or it may be dama-
ged. Furthermore, the CE approval and the guarantee/warranty will expire.
The internally installed device fuse must only be replaced by a specialist.
Before cleaning, switch off the product and disconnect it from the mains voltage; pull the mains
plug from the mains socket. Disconnect all connected devices from the product as well.
Only clean the product with a soft, clean, dry and lint-free cloth. Never use any cleaning
agents, since this might damage the surface of the casing and label.
Dust can be removed using a clean, soft brush and a vacuum cleaner.