Instructions

Error message Beep LED
indicator
Switch
position
Description
Error 8 (ERR8) Battery voltage too low
Error 9 (ERR9) Voltage input error
Error a (ERRa) Thebatterytype(switch
position) was changed
during the charging process,
or the battery was charged
for too long.
Please read the following section carefully before connecting or charging/discharging a battery.
• Read the information in sections 5 and 6.
• Doyouknowthebattery’sspecications?Donotconnectabatteryifthespecicationsare
not printed on the casing.
• Have you selected the correct charging mode for the type of battery you are using? Selecting
thewrongmodemaydamagethechargerandthebatteryandcauseareorexplosion!
• Have you selected the correct charging current?
• Areallcablesandplugsintact?Dotheplugstsecurelyintothesockets?Worn-outplugsand
damaged cables should be replaced.
• Connectamaximumofonebatterytoeachchannel.Youcanchargeuptofourbatteriesat
the same time.
• Always connect the cable to the charger before connecting it to the battery. When disconnect-
ing,proceedinthereverseorder–disconnecttherechargeablebatteryfromthecharging
cable, and then unplug the cable from the charger.
• Disconnectinginthewrongordermayleadtoashortcircuit,whichcancauseareorexplo-
sion!
34