Instructions

Usebutton1(channel)toselectthechargingoutput(CH1-CH4)thatthebatteryisconnectedto.
Usebuttons2(DEC-)and3(INC+)toadjustthemaximumchargingcurrentbetween0.1Aand
1Ain0.1Aincrements.Aftersettingthemaximumchargingcurrent,pressbutton4(START/
STOP) for 2 seconds to start the charging process.
Pressbutton4(START/STOP)tostopthechargingprocess.
Whenthebatteryischarging,thedisplayforeachchannelalternatesbetweenthemaximum
current and voltage every 5 seconds.
The charger must be placed on a dry, level surface. The ventilation holes must not be
obstructed. Rechargeable batteries generate heat when they are charging/discharg-
ing.The heatmust be dissipated bya suitable coolingsystem. Excessive battery
temperaturescanraisetheriskofareandcausethebatteriestoagemorequickly.
Remove the battery from the charger when the charging process is complete.
After charging the battery, remove it from the charger, otherwise it will automatically
start to discharge. Constantly charging and discharging the battery will cause it to age
more quickly.
 Beforechangingthemaximumchargingcurrent,pressbutton4tostopthecharging
process.
9. Error messages
Error message Beep LED
indicator
Switch
position
Description
Error 1 (ERR1) Overvoltage
Error 2 (ERR2) Defective power supply
Error 3 (ERR3) Excessivechargertem-
perature
Error 4 (ERR4) Excessivecurrent
Error 5 (ERR5) Constant Alternating
red/green
LiPo or
LIHV
No battery was detected on
this channel.
Error 6 (ERR6) Incorrect battery polarity
Error 7 (ERR7) Excessivebatteryvoltage
33