Manual

PTM-100 Operation | 6
B-H86.0.02A.DB214-1.0 13 / 26
6 Operation
6.1 Commissioning
6.1.1 Explanation
Description
The product is switched on with the On/Off button. It may be necessary to configure
the product after switching on. See Configuration [}p.13].
Prerequisite
– Sufficiently full batteries are inserted in the product.
Instruction
– Press On/Off button.
Outcome of an action
Information about the configuration of the product appears in the display.
POFF
Automatic shut-
off
Automatic shut-off activated. The product is
switched off if no buttons have been pressed after
the adjusted time
T.OF
Zero point correc-
tion
If a zero point correction of the temperature sensor
was made
T.SL
Gradient correc-
tion
If a gradient correction of the temperature sensor
was made
The product is now ready for measurement.
6.2 Configuration
6.2.1 Explanation
The following steps describe how to adapt the product for your purposes.
NOTE
There are various configuration parameters available depending on the product ver-
sion and configuration. They can differ depending on the product version and configur-
ation.
6.2.2 Opening the configuration menu
Description
In order to configure the product, you must first open the Configuration menu. The
menu is opened as shown in the illustration.
Prerequisite
– The product is switched on.
Instruction
1. Press the Function key for 2 seconds to open the Configuration menu.
2. (ONF appears in the display. Release the function key.
3. By briefly pressing the Function key, you can scroll through the parameters. Select
the parameter you would like to configure.
4. When you have selected the desired parameter, change the parameter to the de-
sired value with the Up button and the Down button.
5. The changes are saved after running through the entire Configuration menu. STOR
appears in the display. The Configuration menu can be exited from any arbitrary
parameter by pressing and holding the Function key for 2 seconds. The changes
made up that point are saved.