Instructions
46
1. Remove any connected consumers from the output.
2. Switch on the power unit at the power switch (5). The operating display (1) lights up and the current
and voltage display appears on the display.
3. Set the parameters according to your specications as described in the chapter “Start-Up”.
4. Check once more that the correct output voltage is set.
5. Connect the plus pole (+) of the consumer with the red socket “+” and the minus pole (-) of the
consumer with the black socket “-” of the respective output (front = “AUX. OUTPUT” (6), rear =
“MAIN OUTPUT”(7)).
Now you can switch on the connected consumer.
The current consumption of the connected consumer is displayed in Ampere (A) in the display (1).
10. MEMORY SLOT OPERATION “PRESET” AND “SET”
Three xed voltages, including current settings, can be stored in the device with the “Set” function and
directly selected through the “Preset” function.
Ex works, all three memory slots (P1, P2, P3) are preset.
They are assigned as follows:
Memory
Type
P1 P2 P3
Voltage Current Voltage Current Voltage Current
PPS 11810 5 V Maximum 13.8 V Maximum 15 V Maximum
PPS 11360 5 V Maximum 13.8 V Maximum 25 V Maximum
PPS 11603 5 V Maximum 13.8 V Maximum 55 V Maximum
PPS 13610 5 V Maximum 13.8 V Maximum 15 V Maximum
PPS 16005 5 V Maximum 13.8 V Maximum 25 V Maximum
PPS 11815 5 V Maximum 13.8 V Maximum 55 V Maximum