Safety data sheet

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no. 101137
Material Safety Data Sheet
Page 3 of 7
6. Accidental Release Measures:
Spill response notice:
Only persons properly qualified to respond to an emergency involving hazardous substances may respond to a spill according
to federal regulations (OSHA 29 CFR 1910.120(a)(v)) and per your company´s emergency response plan and
guidelines/procedures. See section 13, special instructions for disposal assistance.
Cleanup technique:
Absorb spilled liquuid with non-reactive sorbent material. Sweep up material. Place material in a plastic bag. Mark bag „Non-
hazardous trash“ and dispose of as normal refues. Decontaminate the area of the spill with a soap solution.
Evacuation procedure:
Evacuate as needed to perform spill clean-up. If conditions warrant, increase the size of evacuation.
Special instructions (for accidental release):
Not applicable.
304 EHS RQ (40 CFR 355):
Not applicable.
D.O.T. emergency response guide number:
Not allocated.
7. Handling and Storage:
Storage requirements:
Store at controlled room temp in dry location. Avoid high temperatures and high humidities. Keep container close when not in
use.
Handling precautions:
Pertains only to bulk powder handling
Ventilation:
Use adequate general or local ventilation to keep fume and dust levels as low as possible.
Respiration protection:
Use NIOSH approved dust respirator when handling bulk powder.
Eye protection:
Chemical splash goggles with side shields when handling bulk powder.
Gloves:
Natural rubber, butyl neoprene or equivalent. Wear full cover clothing when handling bulk powder.
Do not breath dust. Do not get into eyes. Avoid prolonged or repeated skin contact. Wash with cold water after
contact. Do not take internally.