Owner's Manual
Table Of Contents
- 2 Einführung
- 3 Bestimmungsgemäße Verwendung
- 4 Lieferumfang
- 5 Aktuelle Bedienungsanleitungen
- 6 Symbolerklärung
- 7 Sicherheitshinweise
- 8 Bedienelemente und Komponenten
- 9 Produktbeschreibung
- 10 Displayanzeigen und Symbole
- 11 Messbetrieb
- 11.1 Messgerät einschalten
- 11.2 Spannungsmessung “V”
- 11.3 Strommessung „A“
- 11.4 Widerstandsmessung
- 11.5 Diodenprüfung
- 11.6 Durchgangsprüfung
- 11.7 Messung der Kapazität
- 11.8 Berührungslose Wechselspannungsdetektion „NCV“
- 11.9 Frequenzmessung
- 11.10 Pulsweitenmessung
- 11.11 Raumtemperatur- und Luftfeuchtemessung
- 11.12 Temperaturmessung mit Kontaktfühler
- 11.13 Schallpegelmessung
- 11.14 Beleuchtungsmessung
- 11.15 RANGE-Taste
- 11.16 Taste REL
- 11.17 Taste Hz%
- 11.18 HOLD-Taste
- 11.19 MODE-Taste
- 11.20 Abschaltautomatik
- 11.21 Displaybeleuchtung
- 12 Fehlersuche
- 13 Reinigung und Pflege
- 14 Entsorgung
- 15 Technische Daten
- 2 Introduction
- 3 Intended use
- 4 Delivery content
- 5 Up-to-date operating instructions
- 6 Description of symbols
- 7 Safety instructions
- 8 Operating elements
- 9 Product description
- 10 Display indications and symbols
- 11 Measuring
- 11.1 Switching on the measuring instrument
- 11.2 Voltage measurement “V”
- 11.3 Current measurement “A” 10
- 11.4 Resistance measurement
- 11.5 Diode test
- 11.6 Continuity test
- 11.7 Capacity measurement
- 11.8 Contact-free AC voltage detection “NCV”
- 11.9 Frequency measurement
- 11.10 Pulse width measurement
- 11.11 Room temperature and humidity measurement
- 11.12 Temperature measurement with contact sensor
- 11.13 Noise level measurement
- 11.14 Lighting measurement
- 11.15 RANGE button
- 11.16 REL button
- 11.17 Hz% button
- 11.18 HOLD button
- 11.19 MODE button
- 11.20 Auto power-off function
- 11.21 Display illumination
- 12 Troubleshooting
- 13 Cleaning and care
- 14 Disposal
- 15 Technical data
- 2 Introduction
- 3 Utilisation prévue
- 4 Contenu de l’emballage
- 5 Mode d’emploi actualisé
- 6 Description des symboles
- 7 Consignes de sécurité
- 8 Éléments de fonctionnement
- 9 Description du produit
- 10 Indications apparaissant à l’écran et symboles
- 11 Mesures
- 11.1 Mise en marche de l’appareil de mesure
- 11.2 Mesure de la tension « V »
- 11.3 Mesure du courant « A »
- 11.4 Mesure de la résistance
- 11.5 Test de diode
- 11.6 Contrôle de continuité
- 11.7 Mesure de la capacité
- 11.8 Détection sans contact de la tension alternative « NCV »
- 11.9 Mesure de fréquence
- 11.10 Mesure des largeurs d’impulsions
- 11.11 Mesure de la température ambiante et de l’humidité de l’air
- 11.12 Mesure de la température avec sonde à contact
- 11.13 Mesure du niveau sonore
- 11.14 Mesure de la luminosité
- 11.15 Touche RANGE
- 11.16 Touche REL
- 11.17 Touche Hz%
- 11.18 Bouton HOLD
- 11.19 Bouton MODE
- 11.20 Fonction de désactivation (OFF) automatique
- 11.21 Eclairage de l’écran
- 12 Dysfonctionnements
- 13 Nettoyage et entretien
- 14 Élimination des déchetsd
- 15 Caractéristiques techniques
- 2 Inleiding
- 3 Beoogd gebruik
- 4 Leveringsomvang
- 5 Meest recente gebruiksaanwijzing
- 6 Beschrijving van de symbolen
- 7 Veiligheidsinstructies
- 8 Bedieningselementen
- 9 Productbeschrijving
- 10 Indicaties en symbolen op de display
- 11 Meten
- 11.1 Meetapparaat inschakelen
- 11.2 Spanningsmeting “V”
- 11.3 Stroommeting “A”
- 11.4 Weerstandsmeting
- 11.5 Diodetest
- 11.6 Doorgangstest
- 11.7 Capaciteitsmeting
- 11.8 Contactloze wisselspanningsdetectie “NCV”
- 11.9 Frequentiemeting
- 11.10 Pulsbreedtemeting
- 11.11 Kamertemperatuur- en luchtvochtigheidmeting
- 11.12 Temperatuurmeting met contactsensor
- 11.13 Geluidsniveaumeting
- 11.14 Belichtingsmeting
- 11.15 RANGE-toets
- 11.16 REL-toets
- 11.17 Hz/%-toets
- 11.18 HOLD-toets
- 11.19 MODE-toets
- 11.20 Automatische uitschakelfunctie
- 11.21 Displayverlichting
- 12 Probleemoplossing
- 13 Onderhoud en reiniging
- 14 Verwijdering
- 15 Technische gegevens
2 Introduction
Dear customer,
Thank you for purchasing this product�
If there are any technical questions, please contact:
www�conrad�com/contact
3 Intended use
– Measuring and displaying electric parameters in the range of excess voltage category III (up to max� 600V
against ground potential, pursuant to EN 61010-1) and all lower categories� The measuring device and equip-
ment must not be used in the overvoltage category CAT IV (e�g� at the low voltage installation source�)
– Measurement of direct and alternating voltage up to a maximum of 600 V
– Measurement of direct and alternating current up to 10 A
– Measuring resistance values of up to 40 MΩ
– Continuity test (< 50 Ω acoustic)
– Diode Test
– Capacity measuring up to 100 μF
– Frequency measurement up to 10 MHz
– Pulse width display in %
– Temperature measurement with external K-type sensor from -20 to +1300 °C
– Temperature measurement with internal sensor from 0 to +50 °C
– Measuring the relative air humidity form 33 - 99 %
– Measuring the illumination strength up to 40 000 Lux
– Measuring the noise level of 35 -100 dBC (for orientation measurement)
– Contact-free AC voltage detection “NCV”
The measurement functions are selected using the dial switch� Except for the environmental measuring ranges of
temperature, humidity, noise level and illumination strength, automatic measuring range selection is active in all
measuring ranges (autorange)�
The two current measuring inputs are secured against overload with ceramic high-performance fuses�
The voltage in the measuring circuit may not exceed 600 V�
The multimeter is operated with a common 9 V alkaline battery block� The device may only be operated with the
specied batteries.
For safety reasons, only use measuring cables or accessories which are adjusted to the specications of the multi-
meter when measuring�
If you use the product for purposes other than those described, the product may be damaged� Improper use can
result in short circuits, res, electric shocks or other hazards.
The product complies with the statutory national and European requirements� For safety and approval purposes,
you must not rebuild and/or modify the product�
Read the operating instructions carefully and store them in a safe place� Make this product available to third parties
only together with the operating instructions�
All company names and product names are trademarks of their respective owners� All rights reserved�
33