User manual

D9 c) For setting a high and low limit (Hi) and (Lo), press the "RANGE” but-

ton before you enter the set mode to set the desired measuring range

for the high and low limit. Then press the "SET” button to reach the set

mode and then the "Hi/Lo" button. The arrow symbol "^" will flash,

and on its right 4

digits for setting the value.

When the half digit flashes, only the numbers "1" or "0" (=blank) can

be set.

For the other four digits, the numbers from 0 to 9 are possible. After

entering the number, the next digit will flash.

When the setting of the high limit is done, press the "ENTER" button

(PAL SER) to confirm the lower limit. (Arrow symbol " "). Proceed in

the same way as for setting the high limit. Make sure that the set val-

ue is below the upper limit, otherwise ".Err" for error will be displayed

and the measuring instrument will switch to the upper limit.

When the setting of the lower limit is done, press the "ENTER” button

for confirmation and return to the normal mode automatically.

D9 d) For setting the tolerance limits (when measuring tolerances) press the

"RANGE” button before you enter the set mode to select the desired

range for the upper and lower tolerance.

Then press the SET button to reach the set mode and then the "TOL"

button. The "TOL” symbol above the large display will flash and

beneath it, the left digit of the 4

digits for setting the value.

This value will be needed for measuring tolerance (described in detail

below) without tolerance standards (in [%]).

When the setting is done, press the "ENTER" button (PAL SER). The

arrow symbol "^" will flash, and on its right 4

digits for setting the

value.