User manual

30
If you are not sure about the correct connection or use, or if questions arise which are not covered
by these operating instructions, please do not hesitate to contact our technical support or another
qualied specialist.
6. OPERATING ELEMENTS
See fold-out page
1. SELECT button
2. Non-contact voltage sensor
3. Torch light
4. LC display
5. Rotary switch
6. Battery compartment
7. Stand clamp
8. mA µA
Hz%VΩ socket
9. COM socket (reference potential)
10. 10A max socket
11. Torch button
12. HOLD / BACK LIGHT button
7. DISPLAY INDICATIONS AND SYMBOLS
Battery replacement icon; please replace the battery as soon as possible
Symbol for the diode test
Lightning icon for voltage measuring
Symbol for the acoustic continuity tester
~ AC Alternating current
DC Direct current
Symbol for active hold function
Ω Ohm (unit of electric resistance)
kΩ Kiloohm (exp.3)
MΩ Megaohm (exp.6)
OL Overload, the measuring range was exceeded
V Volt (unit of electric potential)
A Ampere (unit of electric current strength)
mA Milli ampere (exp.-3)
µA Microampere (exp.-6)
Hz Hertz (unit of frequency)
kHz Kilohertz (exp.3)
MHz Megahertz (exp.6)
% Display of the pulse/break ratio (duty cycle)
Delta symbol for active relative measuring function
Auto Range Automatic measuring range selection
Capacitance
nF Nano farad (exp. -9) (unit of capacity)
µF Micro farad (exp. -6) (unit of capacity)