User manual

34
Connect the plus pole (+) of the consumer with the red socket “+” and the minus pole (-) of the consumer with
the blue socket “-” of the respective output (front = “AUX. OUTPUT”, rear = “MAIN OUTPUT”).
Now you can switch on the connected consumer.
☞
The current consumption of the connected consumer is displayed in Ampere (A) in the
display (3).
Memory Slot Operation “Preset” and “Set”
Three fixed voltages, including current settings, can be stored in the device with the “Set” function and
directly selected through the “Preset” function.
Ex works, all three memory slots (P1, P2, P3) are preset.
They are assigned as follows
Memory P1 P2 P3
Type Voltage Current Voltage Current Voltage Current
HPS-11530 15 V
HPS-11560 15 V
HPS-13015 5 V Maximum 13.8 V Maximum 25 V Maximum
HPS-13030 25 V
HPS-16015 55 V

Make sure that no consumers are connected.
Activate the “Preset” function through the “MODE” (13) slider on
the rear. Put the switch in the “Preset” position. The front LED dis-
play “REAR CONTROL” (6) lights up. The front rotary controls are
now inactive.