User manual

Intended Use
The remote control is used for setting, reading and controlling the
VOLTCRAFT converter series SWD from 300 to 2000 VA. The
remote control is suitable for 12 V and 24 V types alike.
Four buttons and a graphical display can be used to set and read
all parameters. The data for input voltage, output voltage, perfor-
mance and output status can be stored with date and time to any
common SD memory card (at least 1 GB, no SDHC!) at an interval
of 30 seconds. The data is available as a HTML file for direct view-
ing or display in table programmes.
The connection and power supply of the FB-02 SWD is directly via
the converter and through a USB cable (type A USB plug -> type A
USB plug). An integrated lithium button cell warrants power supply
to time and date when the converter is switched off.
In the FB-03 SWD, data transfer is by radio connection. A radio
stick is plugged in at the converter, which then sends the files
wirelessly to the remote control. The radio receiver and a Li Ion
battery are already integrated in the FB-03 SWD.
The Li-Ion battery of the FB-03 is charged from mains voltage
through the included mains adapter.
Use other than that described above may lead to damage to the
product and injury. No part of the product should be modified or
rebuilt!
Operation under adverse environmental conditions is not permit-
ted. Adverse environmental conditions are ambience tempera-
tures >50°C, moisture or excessive humidity (>80% relative
29