User manual

4.Advanced User Guidebook
64
How to Clone and Recall a waveform
You can clone the waveform of one channel between two cursors, and save it in the
internal memory or on a USB memory device. You can save four cloned waveforms
in the instrument internal memory. The waveform files saved to a USB memory
device are saved with the extension "ota".
You can output the stored waveform from a file in the internal memory or in a USB
memory device; and the waveform between two cursors can be output directly
without save operation.
Clone Wave menu shows as follows:
Menu
Setting
Instruction
Source
CH1
CH2
Clone the waveform of CH1
Clone the waveform of CH2
Line
a
b
ab
x
Turn the M knob to move line a.
Turn the M knob to move line b.
Two cursors are linked. Turn the M knob to move the
pair of cursors.
Set the cursors to select the entire screen automatically.
Clone Clone
Clone the waveform between two cursors, and output it
through the generator.
Save
Save
Save the waveform between two cursors
Memory
Internal
USB
Select the memory location
Output
(Internal memory is selected)
Output the waveform in the selected object on the left
To clone waveform and save to the internal/USB memory:
(1) Push Save button.
(2) Select Type in the bottom menu, in the left menu, turn the M knob to select
Clone.
(3) Select Source in the bottom menu, select one channel (CH1/CH2) in the right
menu for Source.
(4) Select Line in the bottom menu. If a or b is selected, turn the M knob to move the
cursor. If ab is selected, turn the M knob to move the pair of cursors. If x is
selected, the entire screen will be selected automatically. The waveform
information is displayed at the left bottom corner of the screen.
Length
Frequency
Time
Note: If (or ) appears in the information or a
message "Waveform points beyond the limit." appears on the screen, that
means the length of the cloned waveform exceeds the limit. The maximum length