User manual

DSO-2020 USB
4.1 Sample Measurement
To acquire and display a signal, please do the steps as follows:
Connect signal to CH1 by using probe
The oscilloscope set the vertical, horizontal, and triggers controls at the best status
automatically. Also, you can adjust the controls to meet your measurement to optimize the
waveform display.
1. To measure the frequency and “Vpp”, you can do these steps as follows:
2. Click the
button, the frequency of the signal display on the bottom of
the waveform interface.
3. Click the
button, the “Vpp” of the signal will also display on the
bottom of the waveform interface.
4. To clear the measurement on the waveform interface, click the
button.
User’s Manual 50