User Guide

3
.
User Guidebook
7
No.
Name
Description
20
AC Power input
connector
Connect the supplied AC power cord to this
connector.
21
Fuse holder
Fuse rating is 1A, T class, 250 V.
General Inspection
After you get a new oscilloscope, it is recommended that you should make a check
on the instrument according to the following steps:
1. Check whether there is any damage caused by transportation.
If it is found that the packaging carton or the foamed plastic protection cushion
has suffered serious damage, do not throw it away first till the complete device
and its accessories succeed in the electrical and mechanical property tests.
2. Check the Accessories
The supplied accessories have been already described in the "Appendix A:
Enclosure" of this manual. You can check whether there is any loss of
accessories with reference to this description. If it is found that there is any
accessory lost or damaged, please get in touch with the distributor of our
responsible for this service or our local offices.
3. Check the Complete Instrument
If it is found that there is damage to the appearance of the instrument, or the
instrument can not work normally, or fails in the performance test, please get in
touch with our distributor responsible for this business or our local offices. If
there is damage to the instrument caused by the transportation, please keep
the package. With the transportation department or our distributor responsible
for this business informed about it, a repairing or replacement of the instrument
will be arranged by the us.
Basic Operation
1. Set the switches and controls on the front panel as shown below.
Position for control switches
Item
No. in Figure 3- 1 Front panel
Setting
Power switch
19
○
pressed down
Volts/DIV
16
0.1 V
Norm/Auto/TV
8
Auto
Time/DIV
6
0.5 ms
+/-/XY
15
+