User manual

GETTING STARTED
27
First Time Use
Background
This section describes how to connect a signal,
adjust the scale, and compensate the probe. Before
operating the DSO-1000D in a new environment,
run these steps to make sure the instrument
performs at its full potential.
1. Power On
Follow the procedures on the previous page.
2. Firmware
Update to the latest firmware.
Page 192
3. Reset System
Reset the system by recalling the
factory settings. Press the Default key
on the front panel. For details, see
page 154.
Default
4. Connect Probe
Connect the probe to the Channel 1 input and to
the probe compensation output. This output
provides a 2Vp-p, 1kHz square wave for signal
compensation by default.
Set the probe attenuation to x10 if the probe has
adjustable attenuation.
VARIABLE
POSITION
HORIZONTAL
POSITION
POSITION
POSITION
POSITION
VERTICAL
MATH
REF
BUS
SCALE
TRIGGER
LEVEL
PUSH TO
ZERO
SCALESCALESCALE
PUSH TO
ZERO
PUSH TO
ZERO
PUSH TO
ZERO
PUSH TO
ZERO
PUSH TO
ZERO
SCALE
CH1 CH2 CH3 CH4
2V
CAT I
1M
W
16pF
300Vpk MAX.
Measure
Display
Cursor
Help
APP
Save/Recall
Acquire
Utility
Autoset
Run/Stop
Single
Default
Select
Search
Set/Clear
Zoom
CH1 CH2 CH3 CH4
M
R
B
Menu
50 %
Force-Trig
POWER
x1
x10
X
10
X
1
CH1
2V