Instructions

Digital Storage Oscilloscope 97
Input Impedance,
DC coupled
1MΩ±2% in parallel with 20pF±3pF
Probe
Attenuation
1X, 10X
Supported Probe
Attenuation
Factors
1X, 10X, 100X, 1000X
Maximum Input
Voltage
Overvoltage Category
Maximum Voltage
CAT I and CAT II
300V
RMS
(10×), Installation
Category
CAT III
150V
RMS
(1×)
Installation Category II: derate at 20dB/decade above 100kHz to
13V peak AC at 3MHz* and above. For non-sinusoidal
waveforms, peak value must be less than 450V. Excursion
above 300V should be of less than 100ms duration. RMS signal
level including all DC components removed through AC coupling
must be limited to 300V. If these values are exceeded, damage
to the oscilloscope may occur.
Measurements
Cursors
Voltage difference between cursors: △V
Time difference between cursors: △T
Reciprocal of △T in Hertz (1/ΔT)
Automatic
Measurements
Frequency, Period, Mean, Peak-to-peak, Cycle RMS, PRMS,
Minimum, Maximum, Rise Time, Fall Time, + Width, - Width, +
Duty, - Duty, Base, Top, Middle, Amplitude, Overshoot,
Preshoot, Pmean, FOVShoot, RPREShoot, BWidth, Delay 1-2
↑, Delay 1-2 ↓, LFF, LFR, LRF, LRR, FFR, EFRF
General Specifications
Display
Display Type
7 inch 64K color TFT (diagonal liquid crystal)