User manual

Digital Storage Oscilloscope 47
22 FOVShoot
Defined as (Vmin-Vlow)/Vamp after the waveform
falling.
23 RPREShoot
Defined as (Vmin-
Vlow)/Vamp before the
waveform falling.
24 BWidth
The duration of a burst measured over the entire
waveform.
25 FRR
The time between the first rising edge of source 1
and the first rising edge of source 2 of 50 voltage
level.
26 FFF
The time between the first falling edge of source 1
and the first falling edge of source 2 of 50 voltage
level.
27 FRF
The time between the first rising edge of source 1
and the first falling edge of source 2.
28 FFR
The time between the first falling edge of source 1
and the first rising edge of source 2.
29 LRR
The time between the first rising edge of source 1
and the last rising edge of source 2.
30 LRF
The time between the first rising edge of source 1
and the last falling edge of source 2.
31 LFR
The time between the first falling edge of source 1
and the last rising edge of source 2.
32 LFF
The time between the first falling edge of source 1
and the last falling edge of source 2.
Off Do not take any measurement.
2.10 Acquire
Run Control
Press the [Run/Stop] or [Single] button on the front panel to run or stop the sampling
system of the scope.
When the [Run/Stop] is green, the oscilloscope is running, that is, acquiring data when
trigger conditions are met. To stop acquiring data, press the [Run/Stop] button. When
stopped, the last acquired waveform is displayed.
When the [Run/Stop] button is red, data acquisition is stopped. Red "Stop" is