Instructions

Digital Storage Oscilloscope 44
in this mode. As this measurement uses the waveform record points, it is more precise
than the graticule and cursor measurements. Automatic measurements show the
measurement results by readouts which are periodically updated with the new data
acquired by the oscilloscope.
Push the Meas button to perform auto measurements. There are 32 types of
measurements and up to 4 can be displayed at a time.
Perform the steps below and select voltage or time parameters to make automatic
measurements.
1. Press the [Meas] button on the front panel to enter the Measure function menu.
2. Press the Source softkey, and then use the Universal Knob to select the desired
channel.
3. Press the Type softkey, and then turn the Universal Knob to select the desired
measurement parameter.
4. Press the Universal Knob to add the measurement parameter, the parameters and
value will be shown above the menu, and the statistics status will update.
5. To turn off the statistic function, press the Statistics softkey to select OFF.
The measurement display area can display 4 measurement parameters at most, and
the measurements will arrange according to the selecting order. If add a sixth
measurement parameter, it will delete the first measurement.
Note: If the parameter does not match the measured condition, it will display as “*****”.
To Clear Measurement Parameters
Press the Clear All softkey to clear all the measurement parameters that are displaying
on the screen.
Statistic Function
Make statistic and display the current, average, minimum, maximum, root mean square
error and count values of at most 4 measurement items that are turned on last.
1. Press the [Meas] button on the front panel to enter the Measure function menu.
2. Press the Statistics softkey to select ON.